The IPV3 By Pioneer4You
The iPV V3 is a powerhouse of a box mod. This variable wattage mod will allow you to fine-tune your vaping experience by adjusting your power from 7W to 150W in increments of 0.1W! Above 80W the device adjusts in 1W increments, and allows for up to 5 preset programmable wattages. Able to fire coils at 0.1Ω up to 3.0Ω, this mod is powered by dual IMR 18650 batteries and is capable of producing up to 150 watts of power! The batteries are removable for separate charging and swapping with fresh batteries. The OLED screen is very easy to read, and will tell you your wattage, resistance, output voltage and battery life at a glance, without having to fumble through menus. In addition to the tactile firing button on the side, the device features two buttons for wattage adjustments. The iPV V3 has 510 threading with a spring-loaded connection, but will accept any 510 to eGo adapter if you'd like to use eGo-threaded atomizers. This mod is made of high-quality anodized aluminum, and provides more than enough power for beginners and veterans alike!
Note: The included Micro-USB cable does not charge the device. The cable is strictly for firmware updates. This device does not have onboard charging like the iPV V2 or V2.1 due to its dual-battery configuration.
Caution: We recommend only using batteries with a Continuous Discharge Rate of 20A or higher!
Specifications and Features:
Output Power: 7W - 150W
Output Voltage: 1V - 7V
Input Current: 1.3A - 30A
Input Voltage: 6.2V - 8.5V
Loading Resistance: 0.1Ω - 3.0Ω
Screen Size: 0.96" OLED
Low Voltage Protection
Low Resistance Protection
High Input Voltage Warning
Output Short Circuit Protection
Reverse Battery Protection
Power On/Off: Click the firing button 5 times.
Adjust Wattage: Click or hold the + or - button to increase or decrease wattage, respectively.
Lock/Unlock: Click and hold both the + and - buttons simultaneously. The screen will indicate that this has been done correctly.
Programming Wattage Memory: Press and hold the + button until memory settings are indicated by displaying M1, M2, M3, etc. To change the set wattage for the current memory setting, press the - button then adjust up or down to the desired wattage. Pressing the fire button will lock that wattage to the current memory setting.
$139.99 - Sold Out
The HCigar VT133 Dual 18650 DNA200 box mod is HCigar’s 18650 version of the VT200. The VT200 was one of the most successful DNA200 devices to hit the market due to its extremely high quality and master cratsmenship. The HCigar VT133 uses the same quality...
$99.99 - Sold Out
Introducing the VT75 from HCigar. Utilizing Evolv's DNA 75 chipset, the VT75 offers all of the same amazing features as the DNA 200 but with a Max Wattage of 75 watts. The rounded back side fits comfortably in your hand and it's texture is rugged,...
IPV Mini 2 70W Box Mod by Pioneer4you is the upgraded version of the very popular IPV Mini 30W. While maintaining the same size and shape as it's predecessor, the IPV Mini 2 features a Yihi SX330V2C chip that allows the regulated, miniature mod to...